Featured Products

Qscan Outdoor 2-D Scanner

Qscan Mini Turnstile and Kiosk Wiegand 12V Imager

Ble1 Bluetooth/Prox Reader

Sproxjx Tri-Technology Reader (barcode / mag / prox)

QscanT Turnstile reader Wiegand 12V Imager with prox and 13.5 Mhz

Smart Prox SA

Stand-Alone proximity reader with optional Barcode and Magnetic Stripe, for Access Control.


The Smart Prox SA is a stand-alone Proximity reader for use in Access Control. The Smart Prox SA can be ordered as a proximity, proximity/magstripe combination, proximity/barcode combination, or proximity/magstripe/barcode combination. With 64k of memory and an internal relay, the SA series is a low-cost solution for controlling door access. The reader contains 64K of memory (256K optional), which is enough to store 6000 9-digit employee numbers. The reader can be downloaded with valid employee numbers from a PC, or enrollment of cards can be done directly at the reader. "Schedules" are also supported in the reader, so that access can be limited to specific days and times for each employee. All you need to control a door is to install the Smart Prox SA with an electric strike or magnetic lock, and you're up and running. The Smart Prox SA supports proximity cards by Farpointe and Hid. For access control which requires monitored access, such as employee ID verification at guard shacks, the SA reader is also available in a portable version with an internal battery. The Smart Prox SA also supports the connection of an external proximity read head. With this option, you can add the flexibility of IBC's SA series readers to your current system using your own proximity head.


Proximity Cards Supported   Farpointe and Hid
Magnetic Stripe   Track 2, Tracks 1&2, or Tracks 2&3, lo/hi co
Scanning Speed   3-30 ips (7-76 cm/sec)
Scan Direction   bi-directional
Symbologies   Code39, 2/5, I2/5, C128, UPCA, EAN13, Codabar
Resolution   7 mil
Read Height   0.4"(1cm) standard, 0.465" optional
Good Read Beep   programmable
Memory   64K standard, 256K optional
Slot Width   0.050"(1.2mm). Other widths upon special request
Indicators   2 leds (programmable)
Light Source   630nm visible, 940nm infrared
Temperature   -40c to +85c
Dimensions   4.6"L x 2.4"W x 1.4" H (11.6cm x 6cm x 3.5cm)
Weight   6 ounces
Material   black polycarbonate (Noryl optional)
Power   5VDC(150ma), 8-15VDC, or 15-30VDC
Standard Wiring   3' (91cm) cable w/flying leads or connectors depending on interface

30VDC 500ma Form C
12VDC 700ma direct from POE

POE to strike   12vdc, max 500ma normally open
Battery Time (portable)   Approximate 4 hours with alkaline 9-volt battery
Available Interfaces:   RS232, RS422, TCP/IP, USB
    RS232, USB (Portable Versions)

Visible or Infrared Optics
1 or 2 tracks
-40c to +85c operation
Reads Kronos Cards

5,12, or 24VDC
256K memory
1 or 2 magstripe tracks
0.400" or 0.465" read height
#6 or 3mm mounting
Side or Rear wiring
Noryl (chemical resistant)
Portable (9 volt battery)

Mounting Kit
Cable for external 9-volt battery (portable version)
Communications cable (portable version)
AC Adapter (portable version)

IBC software   STA V9.4
3rd party software   Highpower Security Products HMS V1.4 (recommended)